Small Footprint and Modern Design
At only 7” deep, the OV200 can be placed against a wall so it doesn’t take up much space in your room.
Attractive neutral color and cool contemporary design that will match any décor. A conversation piece that blends nicely with your room.
3 Stage Filtration
HEPA filter with mini-pleats and foam pre-filter
Activated carbon filter for light odors
Gives you added convenience with full control over the air purifier. There is a convenient remote holder above the carrying handle.
Note: As a safety precaution keep the remote control away from children as you would any device that contains a battery.
Replacement Filter Indicator
Electronic display alerts you when it is time to check the filters.
3 Fan speeds
The built-in dust sensor will measure air quality levels and adjust the fan speed as needed to bring your room to a good (green) air quality.
The sensor needs about 10 minutes to warm up to reach its maximum sensitivity.
If you are sensitive to allergies we suggest running the air purifier on the highest fan speed where the noise is acceptable and not using the Auto mode.
Air Quality Sensor
Measures and displays air quality in color codes: green, yellow and red. The color corresponds to the particle count as measured by the air quality sensor.
- Green: 0-75 ug/m3
- Yellow: 76-150 ug/m3
- Red: >150 ug/ m3
In Night mode, this display is turned off.
Note: air quality sensors like this work in most environments however to set expectations this is not as accurate as the sensors you find in $1,000 laser particle counters.
Cycle through the fan speeds to get to Night Mode. This reduces the fan speed to the quietest level and turns off the air quality display. The blue lights on the top of the user interface will remain on but will be dimmed.
There are 4 timer settings - 1, 2, 4 and 8 hours. The air purifier will turn off after the set time on the timer.
Pressing the Timer and Speed buttons at the same time will lock the air purifier in it’s current state. It can also be locked by pressing the lock icon on the remote. To unlock the air purifier, press and hold these two buttons again at the same time.